Sauna Heater Stove Heating Temperature Control Stainless Steel Home SPA 220-380V

  

Sauna Heater Stove Heating Temperature Control Stainless Steel Home SPA 220-380V. Suitable for medium and small bathroom. The sauna furnace is made of high temperature resistant zinc and magnesium plate with built-in control system placed on the right or left side of the furnace body 2. The control system also has a signal device that displays when the meter and temperature regulator are turned on. Depending on the size of the sauna room, after 30-60 minutes, the sauna stove can reach the set temperature, and the thermostat can ensure that the sauna room maintains an even and comfortable temperature.

The machine is easy to install and can be placed in a sauna room by adjusting the leg support frame. Featuring knob or digital display controller 30-120 degree thermostat and 1-8 hour time controller. Specification: Item Type: Sauna Stove Material: Stainless Steel Power: 6KW Use Space: 5-9m / 16.4-29.5ft Furnace Tube Voltage: 220-380V Suitable for: Apartments, hotels, indoor swimming pools, saunas, sweat rooms, fitness centers and other commercial facilities. 10cm / 3.9in Above 500mm Shelf on the Ground Minimum Distance: Approx. 15cm / 5.9in Suspended Ceiling Minimum Distance: Approx.

110cm / 43.3in Ground Minimum Distance: Approx. 18cm / 7.1in Size: Approx. 57 x 42 x 28.5cm / 22.4 x 16.5 x 11in Weight: Approx. Specification: Item Type: Sauna Stove Material: Stainless Steel Model: SCA - 45W Power: 4.5 KW Use Space: 3-6m Furnace Tube Voltage: 230-240v Suitable for: apartments, hotels, indoor swimming pools, saunas, sweat rooms, fitness centers and other commercial facilities.

8cm / 3.1in Above 500mm Shelf on the Ground Minimum Distance: Approx. 8cm / 3.1in Suspended Ceiling Minimum Distance: Approx. 9800g / 345oz Package List: 1 x Sauna Stove Installation Method: 1. Install the sauna stove to the wall by yourself with the equipped screw; the stove can also be installed with the lowest height of 1900 mm 2. The wall behind the stove shall not be covered with cement, board or similar material.

Because the cladding will cause the wall material to exceed the allowable temperature limit; 3. Qualified materials should be selected for the wall and ceiling; Connection of power cord: 1. Connection of power cord shall be completed by professional electrician with current specifications. Use REVE rubber insulated cable (or similar) to connect to the main power source of the furnace; 2. The connection box of the stove is equipped with a terminal and the section of the connection wire is the same as the power wire of the sauna stove. The junction boxes in the sauna room must be airtight and have moisture condensation holes with a diameter of 7 mm. The center of the box shall not be higher than 500 mm above the ground.

Sauna stones may contain dust, so it is recommended that they be washed before being placed in the stone bin. The largest stones should be placed at the bottom, not too tight, leaving room for ventilation. Stones must be replaced when they begin to peel to avoid damaging the sauna stove. Stones are usually 3-8 centimeters in diameter. Temperature control: thermostat can control the temperature at the ideal state.

Depending on the size of the sauna room, the sauna stove can reach the set temperature after 30-60 minutes. Three - phase thermostat can ensure that the sauna room to maintain a comfortable temperature. Ventilation: in order to make sauna as comfortable as possible, sauna room must have good ventilation. It is best to drill a hole in the wall panel near the bottom of the sauna stove to let air in. The diameter of the air inlet should be at least 6 cm. The air outlet should be on the wall opposite the air inlet and as far away from the air inlet as possible. The air outlet should be twice the diameter of the air inlet and should be as far away from the ground as possible and lower than the upper chair Note: 1. The power switch is the main power switch of the sauna stove. Note that the upper screw should be tightened properly, leaving a 3mm between the screw head and the wall.

We will reply your message within 48 hours. If you do not receive our reply within 48 hours, pls. Post a message again because sometimes our message system may block some emails. If you are satisfied with our service, pls. Our aim is to provide Top Level Customer Service, your recognition will encourage us greatly and serve you better.

We strive to keep all our customers satisfy. We will always do our up most to exceed your expectations in customer service, communication and dispatching of your orders. The item "Sauna Heater Stove Heating Temperature Control Stainless Steel Home SPA 220-380V" is in sale since Thursday, September 19, 2019. This item is in the category "Home & Garden\Yard, Garden & Outdoor Living\Pools & Spas\Saunas".

The seller is "storeshopping2014" and is located in Hongkong. This item can be shipped worldwide.

1. Brand: Unbranded
2. Item Type: Sauna Stove
3. Material: Stainless Steel
4. MPN: Does Not Apply
5. Power: #1 6KW #2 4.5 KW
6. Size: Approx. 57 x 42 x 28.5cm
7. Weight: Approx.